Phone: (07) 5593 6884   Fax: (07) 5593 6885  Email: sales@on-crete.com.au       

HomeAbout UsProductsFlooring SystemsGallerySupportContact Us

FAQ's

 

Can you resurface an exposed agregate driveway?

Yes, additional coats of overcrete are applied until it is built up and no more stones can be seen, then the standard overcrete application process can be used to achieve the decorative look that you require.
 

I have an old stamp concrete driveway that looks like it is faded what can i do to fix it?

Sometimes old decorative driveways look like the colour has faded but this is normally just where the sealer coat has been worn off or broken down from UV rays. If the driveway has been exposed to extreme conditions and not been resealed the colour in the concrete can be worn off. To check what your driveway will look like use a hose and wet down your whole driveway, this is a good guide of what your driveway will look like after a couple of quick coats with our SV24 High Gloss Sealer. If you can still see patches of discoloured areas or bare concrete areas you will have to colour seal your driveway to achieve an even colour or you can resurface it with overcrete.
 

COLOUR CHARTS

 

TECH DATA & APPLICATION SHEETS

EPOXIES

 

MASONARY WATER REPELLENTS

 

MOULD RELEASER

 
PRODUCT DISCLOSURE STATEMENT
ON-CRETE AUSTRALIA PTY LTD. has no control over the use or storage of this product and therefore does not accept any liability in this regard. Any verbal advice given should not be regarded as authoritative information. This is information is subject to change without notice, therefore all applicators should ensure they current information. This product is intended for use for only skilled tradesmen and where applicable statutory licensed tradesmen, experienced and trained in the use of this product. This product is warranted to be of uniform quality within the manufacture’s tolerance. The manufacture over the use or misuse of this product, therefore no warranty rests or implied, is or can be made either as to the effects of such use. The manufacturer’s obligations shall be limited to replacing product proving to be defective.
Copyright 2009 On-Crete Australia Pty Ltd  |  Site by Graphics Online  |  Terms Home  |  Contact  |  Sitemap  |  Bookmark Site  |  Top of page